Hot Splash - Energy-efficient pool heat pump "Sun Spring" 12m³ (3.5 kW)

With the Sun Spring energy-efficient heat pump from Hot Splash, you no longer take an ice-cold dip, but enjoy a wonderful preheated pool! 🏊
So you can extend the swimming season from April to September. That will be great splashing!
Moreover, the heater is very economical to use. The frame is made of high-quality plastic and is corrosion- & UV-resistant.

✅ Ensures a pleasant water temperature
✅ Plug & play: easy installation and user-friendly
✅ Very energy-efficient
✅ Uv- & corrosion-resistant
✅ No Frost™ system
✅ Universal hoses (32 mm): easily connectable to Intex & Bestway pools

In addition to the heater, this set also includes the following parts:
- 2x universal hoses (32 mm)
- 4x hose clamps
- 1x ground switch
- Instructions

For which pool is this heat pump suitable?
The Hot Splash heat pump is suitable for above ground pools up to 12,000 L.

Which filter pump do I need?
This heater works perfectly in combination with a filter pump with a capacity of 2,000 L/h.
Make sure that your filter pump is powerful enough to, in addition to filtering the pool water, also get the water to the heat pump (or other accessories).

What should I pay attention to when installing the heat pump?
Do not place the heater against a wall because the air supply must be able to work properly. In addition, the heat pump must also be able to discharge the expelled air again. A guideline is therefore to leave 80 cm free at the side where the heater is connected to the filter pump (the back) and at least 250 cm at the front, where the fan grill is located. The air blown out by the heat pump is very cold and dry. So it is not recommended to be placed close to your seating area, patio down.

Make sure the distance between the pool and the heat pump is maximum 7 meters. Place the heat pump closer to the pool so that the hot water does not cool down too much when flowing back to the pool. Connect the hoses from the filter pump to the inlet and outlet of the heat pump.

Since the heating element runs on mains electricity, it must be placed near an electrical outlet . Thanks to the plug and play models, the heat pump is connected in no time and you can easily set it up via the control panel.

What is the COP value of this heat pump?
COP represents how efficiently the heat pump converts energy into heat. The higher the value, the less energy the pump needs to heat the water. This heat pump has a COP of 6. This means that the heat pump is able to produce 6 kWh of heat for every kWh of electricity.

Heat output?
At a temperature of 15 °C: 5 kW
At a temperature of 26 °C: 6 kW

🙋‍♂️Tip from poolboy Marcel: to keep the pool water warm as long as possible, it is better to cover the pool in the evening with a cover or combine it with a solar cover.

Maintenance?
Proper maintenance of your heat pump ensures better efficiency, lower energy consumption and, as a result, a lower energy bill. Your heat pump will also last longer! Clean your pump regularly so it can continue to draw air smoothly. Is the swimming season over? Then make the pump water-free & dry and store it frost-free indoors, possibly wrapped in a thermal cloth.

Any more questions about heat pumps? Then be sure to read our FAQ!

About Hot Splash:
With Hot Splash's products, you don't take a refreshing dip, you enjoy a lovely heated pool. Hot Splash guarantees the latest (& sustainable) technologies in pool heating.